2013 12100GSA 90th Anniversary model

[Rev Chuck]

Hi guys! The first time I asked for help on this forum was back in about 2003 when I got an 1100 75th Anniversary Edition, 20yrs later back asking even more questions!
I've read through a whole load of posts regarding the 1200GSA, and in particular the 90th Anniversary model from 2013 - one of which I picked up a week or so ago.
I have two questions,
first, were there no DIN socket outlets on the 1200?
second, this is my own stupid fault, but Is there a particular way of taking the seat off? Put the key into lock, turn it clockwise and take the rear seat off, then turn it anti-clockwise and then try to lift back of front seat but nothing happens. Is there something I am missing at all?
third, were there different colour combinations for 90th anniversary bikes? Mine has fade goldish colour on the beak and down the two side of tank panels - whereas most other I have seen only have the goldish colour on the tank. Any thoughts at all!
TIA.

 

[Schtum]

but Is there a particular way of taking the seat off? Put the key into lock, turn it clockwise and take the rear seat off, then turn it anti-clockwise and then try to lift back of front seat but nothing happens. Is there something I am missing at all?

It's 10 years since I traded in my Twin Cam but from memory.....push down on the rear of the rider's seat as you turn the key to fully release the lock...?

 

[TLSgazza]

My 06 has a din socket under the left side of the seat.if you get your seat off it may be easier to find
As said above try banging the rear of the seat as you turn the key,
I also have one next to the left winglet which is a common upgrade.

 

[dub 24]

Both seats can sometime wedge together where they meet. Push down and back towards the back of the bike while releasing the rear seat. Push down/ thump front seat while releasing the front seat.

 

[Zanussi]

Re the gold lettering along the beak, I would say these are after market added on by a previous owner. I'm on my second 90th and neither had gold letting along the beak. As others have said, check below the seats on the frame , on the left for your socket.

 

[Santa-2512]

Din socket outlets were an option afaik

one LH front section of the combi cluster / one LHS below seat