2610 mounting

[nedflanders]

Thought I'd stick some pics up as I've mounted a 2610 slightly differently so it's not sat on top of the clocks. Didn't want it that high as I found it distracting, wanted it mounted so a quick glance is all thats needed rather than in your face.

This is the view from the riding position, doesn't block the view of the clocks and is easy to reach.

How its mounted, used a ram 3in mount and retapped a ram ball and made a stud to replace the clamp bolt for the bars, Ram are imperial thread and it needs to be metric.

Chuffed to bits with the mounting as although the 2610 is quite bulky it doesnt interfer with anything in this position

 

[GSdude]

Have you done away with the audio cable - meaning you have no voice prompts ?

 

[nedflanders]

No it just runs back under the seat to the intercom

 

[GSdude]

AHA !!!!

 

[RAM-man]

... me thinks, the yoke clamp bit is from Dr. Bob (aka the Telferizer) www.telferizer.com with a short arm, diamond base and cradle (RAM-B-201-A , RAM-B-238 and RAM-HOL-GA9) just in case anyone asks ..

 

[Twotter]

... me thinks, the yoke clamp bit is from Dr. Bob (aka the Telferizer) www.telferizer.com with a short arm, diamond base and cradle (RAM-B-201-A , RAM-B-238 and RAM-HOL-GA9) just in case anyone asks ..

Spotter

 

[nedflanders]

... me thinks, the yoke clamp bit is from Dr. Bob (aka the Telferizer) www.telferizer.com with a short arm, diamond base and cradle (RAM-B-201-A , RAM-B-238 and RAM-HOL-GA9) just in case anyone asks ..

Sorry Ram-man but all the bit's are actually from you at GPSW, all it is is the 3inch arm with a Ram-b-273 just needed to retap the ball and locktight a stud into it and Bob's your uncle