As some will know the back wheel fell off recently, very slow speed and what appeared to be minimal damage, replaced the caliper assembly new brake pads and everything seemed fine.
Just pushed the bike off the centre stand onto side stand heard a big clunk and see that the right hand leg of the c/stand strikes the paralever.
It doesn't happen if I sit on and then push off because my weight keeps it clear.
I've had a good look at it and it appears that the bracket on the remus y pipe may have been bent slightly as the c/stand has a rubber stop which looks like it should rest against it.
If that is the case and the bracket is bent I'm not too concerned I'll bend back a bit.
What is worrying me is, is there a chance the paralever has been compromised in any way.
At the moment it's just got a ding where the stand hit it, it looks to be perfectly OK other than that, looking for advice or reassurance.
Just pushed the bike off the centre stand onto side stand heard a big clunk and see that the right hand leg of the c/stand strikes the paralever.
It doesn't happen if I sit on and then push off because my weight keeps it clear.
I've had a good look at it and it appears that the bracket on the remus y pipe may have been bent slightly as the c/stand has a rubber stop which looks like it should rest against it.
If that is the case and the bracket is bent I'm not too concerned I'll bend back a bit.
What is worrying me is, is there a chance the paralever has been compromised in any way.
At the moment it's just got a ding where the stand hit it, it looks to be perfectly OK other than that, looking for advice or reassurance.
