Just ordered a set of these and am slightly nervous about sawing the end off the bars, especially the throttle end! Anyone done it and got any usefull tips?!
Cheers
Cheers
Acerbis multiplo hand guards for X-challenge
- Thread starter cornish
- Start date
Gaz
Registered user
You don't have to saw anything. You'll have to cut a bit off the grip on the throttle side but that's all.
You will need the Magura fitting kit though so I hope you've specified that one.
You will need the Magura fitting kit though so I hope you've specified that one.
Septimus
Registered user
Yep, I agree. No sawing involved
I used a mallet and tapped the end of the grips until the hollow end of the bars cut a round hole in the end of the grips and that worked a treat....does that make sense
Magura fitting kit too
I used a mallet and tapped the end of the grips until the hollow end of the bars cut a round hole in the end of the grips and that worked a treat....does that make sense
Magura fitting kit too
I'm feeling better already! The fellow I spoke to at the shop said he often had to saw the ends off on other bikes, but had never done a BM. Naturally I feared the worst! I have ordered the magura fittings thanks to reading previous threads. Thanks for the advice.
Similar threads
