is there a favoured fuelling set up for an LC with an Akrapovic full system? Options appear to be do nothing, Power Commander V or ,Hilltop tune. What have the people with full systems done and do their bikes work well?
Akrapovic system set up
- Thread starter trancey
- Start date
I wouldn't 'do nothing' 
If it's a full system, it's in your best interest to i/ finish the job properly and ii/ make the bike a bit richer to protect it. I personally went the Hilltop route, some others have gone power commander. There's probably not much in it to be honest, but either are definitely worth doing.
If it's a full system, it's in your best interest to i/ finish the job properly and ii/ make the bike a bit richer to protect it. I personally went the Hilltop route, some others have gone power commander. There's probably not much in it to be honest, but either are definitely worth doing.
Do you know if disconnecting the lambda sensors when fitting the PCV gives errors on the dash and in the ECU, which will be visible when servicing?
Other company's can tune these too.
Just done mine and had remap by Elite Remaps.
There will be fault codes for the exhaust flap servomotor ,doesn't put any warning light on,and no other effects.
If you disconnect any component there will be fault codes.
Just done mine and had remap by Elite Remaps.
There will be fault codes for the exhaust flap servomotor ,doesn't put any warning light on,and no other effects.
If you disconnect any component there will be fault codes.
Whereaboots, Alex...? Looking them up, there are four agents between the Forth and the Tay and one in Bathgate.
Don't ask him technical questions at this time of night he's probably been on the gin
I am an agent for Elite remaps .
Not all will do bikes.
Not all will do bikes.
Leave the servo motor there, just take out the cables and seal up the holes where they were. No fault code cos it does not know it's gone.
Your wrong, without cables the travel of motor is different. A fault code is set on start up.It does not affect anything and no warning light.
This is using Icom
Damn, wrong again.
I've done exactly that.......
Your wrong, without cables the travel of motor is different. A fault code is set on start up.It does not affect anything and no warning light.
This is using Icom
No fault codes reported by my dealer after a recent service
The probably don't even check for fault codes at a service if theres no complaints .
And if they do they will see you have no Flap fitted so no further action required.
They never mentioned mine.
And if they do they will see you have no Flap fitted so no further action required.
They never mentioned mine.
I've done exactly that.......
No fault codes reported by my dealer after a recent service
Have you made any fuelling changes and, if so, what do you think of the change? PC V or Hilltop tune etc?
All you need to do is type in Hilltop into search and enjoy several days of reading, it has been done to death already.
No, no changes at all, have thought about a hilltop remap but haven't got around to it
GrantR
Registered user
So whereabouts are you and could you do my bike? I'm in Aberdeen and Hilltop is a long way away!!
Similar threads
