anyone with a lathe and a bit of brass?

[autogs]

as title,due to shower fitting cock up,i need a brass spacer/tube,appox 14mm internal,approx 19mm external and 15mm long,any help out there or suggestions,

 

[davegs]

If it's plumbing it should be standard sizes what fitting do you ned it for?.

 

[autogs]

its a makti shower dave,i had to cut down the overhead tube where it bolts down to the glass support,due to a measuring error when i fitted the diverter pipe in the wall.anyway what i did not realise after i cut down the pipe is that the end was made with a integral spacer at the end which i cant get out of the pipe and i need to reinstate to fit it all back

 

[Engineer]

its a makti shower dave,i had to cut down the overhead tube where it bolts down to the glass support,due to a measuring error when i fitted the diverter pipe in the wall.anyway what i did not realise after i cut down the pipe is that the end was made with a integral spacer at the end which i cant get out of the pipe and i need to reinstate to fit it all back

measure twice, cut once

 

[autogs]

measure twice, cut once

yea i know,my father in law did the measurments but forgot to allow for the floor height,going to send the wife to a local eng firm on mon morning.going to fit a 5ft heated towel rail now.

 

[PJ1200]

yea i know,my father in law did the measurments but forgot to allow for the floor height.

Should've got 'Jeff' to do it

 

[autogs]

oi,dont diss the jeff

 

[autogs]

its ok folks problem solved,local machine shop did it today for 15 quid.

now fitted offending shower part and all is good