I have a baglux tank protector for me gsa, i would really appreciate any advice / help how to fit the bugger and where to strap the straps, its a bleeding mystery to me. 
baglux tank protector for gs1150 adventure
- Thread starter fartoofastforme
- Start date
Bigtwin
Guest
1. You dont need to take the tank off, only the OS panel under the tank, and the seat.
2. Get it warm and pliable - airing cupboard is good for that.
3. Clean your tank and polish first.
4. Back loop goes under stickey out bits at bottom rear of tank - line up the filler hole. Rear side clips atach to seam at bottom of tank. Forward ones to sub frame under tank - mind our for the piping under there, use frame only. Middle front one goes under headstock - just thread it through, but don't trap any wires. Side tops go down, round subframe, and back up to themselves.
5. What ever you do, cut off & burn/securely tuck away any extra on the staps, or they will flap about and take the paint off anything (including the forks) in no time at all!!
6. After a bit, tighten everything up a bit, the cover gives a bit as it settles down.
2. Get it warm and pliable - airing cupboard is good for that.
3. Clean your tank and polish first.
4. Back loop goes under stickey out bits at bottom rear of tank - line up the filler hole. Rear side clips atach to seam at bottom of tank. Forward ones to sub frame under tank - mind our for the piping under there, use frame only. Middle front one goes under headstock - just thread it through, but don't trap any wires. Side tops go down, round subframe, and back up to themselves.
5. What ever you do, cut off & burn/securely tuck away any extra on the staps, or they will flap about and take the paint off anything (including the forks) in no time at all!!
6. After a bit, tighten everything up a bit, the cover gives a bit as it settles down.
Similar threads
