Hello all
Does anyone know the required torque for the front pad securing pin ? I know it is held in by a cir-clip but I cannot find a torque setting for it in the Haynes manual.
It is the bolt shown in the centre of the caliper in the attached picture.
Thanks
Rich
Sent from my SM-G935F using Tapatalk
Does anyone know the required torque for the front pad securing pin ? I know it is held in by a cir-clip but I cannot find a torque setting for it in the Haynes manual.
It is the bolt shown in the centre of the caliper in the attached picture.
Thanks
Rich
Sent from my SM-G935F using Tapatalk
