Brake pad securing pin torque

Rich1150

Registered user
Joined
May 31, 2016
Messages
112
Reaction score
0
Location
Newcastle
Hello all

Does anyone know the required torque for the front pad securing pin ? I know it is held in by a cir-clip but I cannot find a torque setting for it in the Haynes manual.
It is the bolt shown in the centre of the caliper in the attached picture.

Thanks
Rich
2f2b71c6e008829c0c7f1e16a3ecf5c6.jpg


Sent from my SM-G935F using Tapatalk
 
Torque settings:
1 Nipitup,
2 tightinough,
3 Goodentight.
You need the first one.:D
Alan R
 
Torque settings:
1 Nipitup,
2 tightinough,
3 Goodentight.

You missed the ooh fuck it’s sheared off / stripped
I deliberately omitted the novice entry level settings of ‘Snapitoff’ and the devastating ‘Fukditup’ as the task at hand in the OP’s question was beyond novice level. These settings are always accompanied by a kerching cash register sound and a glassy eyed parts salesman smile.:eek:
Alan R
 


Back
Top Bottom