brakes

[richard shaw]

started bike today first time for a while ,06 gs with servo brakes ,started ok but servo does not work and DWA comes on the display showing a picture off a battery half charged any ideas !

 

[richard shaw]

DWA is the battery back for my alarm but does any one new how to reboot my servo or is no good!

 

[Pukmeister]

If you have DWA and Servo faults I would strongly suspect your battery terminal voltage is too low. Try charging it.

 

[Danny88]

I had that on my 1150 a few weeks ago seems the abs is very voltage sensitive a charge up of the batt and problem gone.

 

[vfxmark]

If you have DWA and Servo faults I would strongly suspect your battery terminal voltage is too low. Try charging it.

Most likely cause low voltage from battery - causes the computer to fail the system check. Charge the bike or run it for a while and turn it off, turn it on again (letting it re-boot (red triangle to yellow) on switch-on before starting.
Should be fine. Batteries are barely adequate to the task - after a few years they need replacing - consistent ABS faults are a good indication of this even before the starter won't crank the engine.

mark

 

[TLSgazza]

Most likely cause low voltage from battery - causes the computer to fail the system check. Charge the bike or run it for a while and turn it off, turn it on again (letting it re-boot (red triangle to yellow) on switch-on before starting.
Should be fine. Batteries are barely adequate to the task - after a few years they need replacing - consistent ABS faults are a good indication of this even before the starter won't crank the engine.

mark

I think I'm in a time warp

 

[juddadredd]

LMAO I see what you mean, but I consider it to be BAD MANNERS when the OP doesn't post the outcome/fix or whatever, as it looks like a still open post.