- Joined
- Jul 23, 2004
- Messages
- 2,370
- Reaction score
- 123
I would like to fit a set of cone filters to my 40mm CV carbs. At present I have the standrd rubber intake to cylinder hose.
I assume under load, they would eventually work their way off if held only by the jubilee clip.
What is the best way to give the carbs support?
If someone devised a steel bracket, a diagram would be nice unless you have a patent on it
.
The 82 RIOORS motor has an assymetric cam, twin plugged and a 2-1 exhaust system (exhaust have a bigger bore than the standard Keihan).
I assume under load, they would eventually work their way off if held only by the jubilee clip.
What is the best way to give the carbs support?
If someone devised a steel bracket, a diagram would be nice unless you have a patent on it
The 82 RIOORS motor has an assymetric cam, twin plugged and a 2-1 exhaust system (exhaust have a bigger bore than the standard Keihan).