You’ll get there in the end bro, keep goingUpdate. Running better with out the lambda sensors
No abs fault. Took off wheel and cleaned sensor. So that’s a result. Must have been dirty. I’ll give it a good shake down Friday. Thanks for you patience
Again, as am I.Also, the rattle? Turns out it was a Torx bit that had dropped and was stuck between the fuel injector cable and the cylinder head. That would do it! Very relieved I figured that out
See post above, it makes no difference. The grooved end clearly was at the wheel end so reinstall that way if you wish.
No I understood your post and it was much appreciated. I’m just saying that I can’t say which way round it was installed before I took the wheel off this morning because it fell out when I removed the axel! Not that it matters
As I said, about 2.5 k euro. BUT, I had to buy nearly everything. I had some tools but not many. I bought so many little things. They all add up! Feeling good about it all though. I have most if not all the tools one needs to do basic stuff and my favorite is the 5-25 nm torque wrench. It's dinky!
Well done, your bike looks good and you've certainly got to know how it all works whilst fettling it!Just home from work. Spirited spin home. No abs issues. Ride feels good. Tight. Spots are great. Idle a bit lumpy but I’ll have another go Friday. Not sure where I’m going but I think I’m there
Glad the handle bar risers are gone. Feels more suited to my frame. got a few complements off other lads on bikes earlier. Have to say, it does look smart and taken care of. Still loads of bits to do but I'm back on the road
