The Denali instructions say 4Nm torque for both the compressor and horn bracket screws (6mm) - but the same Denali instructions also include a default torque settings table, where they recommend 9Nm torque for 6mm screws.
Now, I know this is a first world problem
however, one torque figure is more than twice the other, and we're talking about a screw into an aluminium housing here, so I want to get it right.
Experiences please - there might be some nuggets, in amongst the incoming fire I'm anticipating
ps - I'm aware of the need to use thread lock and yes, I dd ask Denali, but got no reply.
Now, I know this is a first world problem
however, one torque figure is more than twice the other, and we're talking about a screw into an aluminium housing here, so I want to get it right.Experiences please - there might be some nuggets, in amongst the incoming fire I'm anticipating
ps - I'm aware of the need to use thread lock and yes, I dd ask Denali, but got no reply.
Last edited:
