colint
Registered user
When I dismantled my timing chain case and took off the diode board like a knob I photographed everything except the two wires on the back one spade connector runs vertically one runs horizontally I have a blue wire and a black wire any idea which goes to which
The wires seem to want to go blue on the horizontal spade and black on the vertical spade.
As the bike is fully dismatled and the loom is off I cannot trace via wiring diagram.
The wires seem to want to go blue on the horizontal spade and black on the vertical spade.
As the bike is fully dismatled and the loom is off I cannot trace via wiring diagram.
