others have said the same on that thread so thought it would be of some use here also
Sure, good idea then
Dirty back end
- Thread starter RickSkye
- Start date
Sure, good idea then
I've got a Chinese one on mine with no issues, I put a bit of helicopter tape on the swing arm due to the rubbing comments but it's fine.
Terry
mattgslc
Registered user
you use tape so it doesn't rub ?
so it rubs then lol
garbage to be perfectly honest and the fit isn't that great either , going to adjust it a bit and shape it so it works for now but I will buy a mudsling at some point
No I put tape on because of the comments, but it's fine, that means it's fine no rubbing.
it's a good 1mm away from the swing arm it fits fine too and it's £120 cheaper than the other bit of plastic.
Terry
flatcap007
Registered user
Thats the answer was looking for cheers
mattgslc
Registered user
well I tried to mould it and heat it up and came to conclusion that it doesn't fit well on my 2017 model so I chopped and shaped it at the bottom, when my fat arse is on it I don't have a massive gap as it goes down enough to clear it all and covers the swing arm still
all good now and worth the money even if I did have to chop a bit off lol
all good now and worth the money even if I did have to chop a bit off lol
RickSkye
Registered user
I had better luck with the heat and moulding. Put the bottom of the guard in 4 inches of boiling water. Held it in the shape I wanted and put it in cold water.
Seems to fit with no interferance.
(I did wait until wife went to work before i put pan, water and mud guard on the cooker
)
Sent from my SM-G900F using Tapatalk
Seems to fit with no interferance.
(I did wait until wife went to work before i put pan, water and mud guard on the cooker
)Sent from my SM-G900F using Tapatalk
Similar threads
