Dirty throttle bodies and butterflies

johnpatsa

Registered user
Joined
Jun 25, 2019
Messages
39
Reaction score
0
Location
Greece
After a deep deep servicing.. changing TPS changing all coils with beru cleaning all sensor's and injector's..a found that throttle bodies wey much dirty and the inside paint start to fade a lot... I removed and fully restored it.. cleaned and polished.. tomorrow will install on bike again and synchronize..
b2e42b4ff28930c008943f5859dd8618.jpg
d4d4a0e9a6067180f793d703e261d143.jpg
b52bd4e1254ee84bdce6aaea660386fe.jpg
c1acba5a15ca09667086e5fad8f3dd46.jpg
c5ec979d745ac23e293b6b309fd2a22b.jpg
7dc0017e6421fdf7c201f6c60a846aa7.jpg
b978149aa37bad2a561f573301003be4.jpg
8de1eaab6e06c2fc1b63cf77a6cb03e6.jpg
45616a6adff2095ff4f21075cacae9b5.jpg
788c00efcc8d45e4f786b9fc21c21114.jpg
3882b40517c0411ace355e412d283b0a.jpg
026b2d692d288ac71851c7f7c90a4f00.jpg
ca8e02cad7d087dbad3025c8e67656a1.jpg


Στάλθηκε από το JSN-L21 μου χρησιμοποιώντας Tapatalk
 
I believe (but willing to be corrected) that the throttle bodies are calibrated and factory set and thus should not be adjusted other than by the throttle cable adjusters during balancing. The throttle stop adjuster used to be factory painted in place and capped with a small plastic cover.

By stripping them down for cleaning you may have caused yourself more issues.

They do look much better when clean though.

Did you remove the idle stepper motors and clean the idle air bypass circuit. Mine were filthy inside, easy to park/reset these after cleaning with a GS911.
 
Of course only the cable's you can adjust..the butterflies stop should not be adjusted its from factory...just removed the butterflies and cleaned

Στάλθηκε από το JSN-L21 μου χρησιμοποιώντας Tapatalk
 
I think you can remove without touching the throttle cam stop screw which is factory-set. In any case you can also clean the throttle bodies without removing the butterfly although they don't end up looking quite that clean
 
Yeah we cant touch the stop screw..but can we remove the three secure torx screws and alla the system come off?beacuse i want to polish or Paint with safety the body..as you can see the colour is faded terrible..the correct coloyr was shiny like the part under the tube
2ac2788fcd440ae2b5a77fd8635f9ed7.jpg
dba97d7eda287d8afe0d153dc8878c9a.jpg
2d4984efa57caf951daa0185c6afad46.jpg
d66af5033892ad9744061b3993204725.jpg


Στάλθηκε από το JSN-L21 μου χρησιμοποιώντας Tapatalk
 
Take the proper precautions..............make sure she’s out for the whole day before putting them in the dishwasher
 
Finally fitted and working as new.. really impressed of the idle running..and they look like new..
4bb34093d55a0e8af0ef946c9e16b6e1.jpg


Στάλθηκε από το JSN-L21 μου χρησιμοποιώντας Tapatalk
 


Back
Top Bottom