Im in the process of running the fuel down, also going over every bolt related to the steering and suspension with a torque wrench. The latest thing it did was when turning right out of a junction i felt the front end going left to right several times enough to give me a wobble. I also read somewhere that a problem at the rear of the bike can make it feel like there is a problem at the front. has anyone herd of this? Thanks for all the replies so far!
GSA Tank conversion problem
- Thread starter adamhuntuk
- Start date
- Status
Bendy toy
Registered user
Rear wheel bearing. Swing arm bearings, flat tyres, etc etc.
Sent from a widget that can't spell.
Sent from a widget that can't spell.
WindyChuffer
Registered user
You have added quite a bit of weight to the bike and you seem expect it to handle the same. Which is odd.
If you are doubting this then put original tank back on to will rule out issues with the bike.
Other than that, just get used to it.
Btw - why do you need the bigger tank?
If you are doubting this then put original tank back on to will rule out issues with the bike.
Other than that, just get used to it.
Btw - why do you need the bigger tank?
Finished going through all bolts relating so steering and suspension and everything is correct. Tanks still not empty so will report back when done. The only thing i have come across was a picture in the reprom while looking over the work i did on the front suspension. Its referred to as an anti twist lock and i dont recall seeing it when i did the work or can see it now. I believe its just to keep the ESA body from moving. I remember removing the ESA and remember unbolting a cage that was holding it but nothing like this. I have attached the picture below. I dont think this is whats causing the handling issues but would like to rule it out. Thanks for any help in advance.
Bendy toy
Registered user
There are at least two models of ESA.
Sent from a widget that can't spell.
Sent from a widget that can't spell.
WindyChuffer
Registered user
So have you put original tank back on yet, and got back to a last known good configuration?
No not yet, Im running the tank down at the moment but not had much chance to use the bike over the last week. if an empty tank makes no difference i will start stripping bits off back to when it was working. will report back when done!
- Status
Similar threads
