H&B ENGINE AND LIGHT BAR TORQUES

[THE PICT]

TOOK OFF MY H&B ENGINE AND LIGHT BARS TODAT TO GIVE THEM A WEE LICK OF PAINT AS THE SALTS CORRODED THEM OVER THE WINTER. DOES ANYONE HAVE THE TORQUE SETTINGS FOR THE BOLTS WHEN I PUT THEM BACK ON? THREW MY INSRUCTIONS AWAY LONG TIME AGO. CHEERS

 

[(RIP) maverick]

The four rear bolts on the H&B bars is between 42-45NM, not sure what the bolts on the front under the tank should be.

 

[MasterDabber]

[B not sure what the bolts on the front under the tank should be. [/B]

As it is the bolt holding the fairing bracket to the frame, I think it would be 21Nm.

 

[(RIP) maverick]

As it is the bolt holding the fairing bracket to the frame, I think it would be 21Nm.

That sounds right as my book of useless haynes information is packed away for our house move.

 

[Mick_rw]

Correct...

As it is the bolt holding the fairing bracket to the frame, I think it would be 21Nm.

it is 21Nm in my thread in Hepco & Becker engine bars missed resetting my torque wrench after doing rear two bolts and sheared the front one....

Mick

 

[THE PICT]

CHEERS GUYS