H & B engine bar fitting procedure ?

[Clive795]

I know this has been on the boards before but I have searched and can't find the answer I need.

I think I will buy a set of these bars but I just need to be reassured that I will be able to fit them.
I think that I have all the tools mentioned in another posting but could someone confirm that I do not have to remove the front wheel ( as appears to be the case with Wunderlich bars !)

Please be gentle with me over this, the bike is only 1000 miles old and I don't want to break it yet with my somewhat limited spanner skills.

 

[TheJoker]

I know this has been on the boards before but I have searched and can't find the answer I need.

I think I will buy a set of these bars but I just need to be reassured that I will be able to fit them.
I think that I have all the tools mentioned in another posting but could someone confirm that I do not have to remove the front wheel ( as appears to be the case with Wunderlich bars !)

Please be gentle with me over this, the bike is only 1000 miles old and I don't want to break it yet with my somewhat limited spanner skills.

Clive,

Have a look here:
http://www.ukgser.com/forums/showthread.php?s=&threadid=22998
Page 3 has got instructions from... erhm... Clive!

You don't have to remove the front wheel, in fact, you only have to remove 3 bolts, and put new ones back (8 in total). Quite easy, as long as you get the bars to fit onto themselves.

Follow the instructions and you'll be fine!