I bought a heated waistcoat for Mandy during the week. Thanks Thunder.
It is a Chili and is fitted with a BMW type plug.
It would be pretty awkward for Mandy to use the standard socket on the 1150 so I had a wee look around today to see where would be a handy spot to add an additional socket.
A quick look confirmed that there was enough space for the body of the socket so I decided to put it here;
An 18mm hole was drilled out to take the unit then the cable was fed through the hole. I put some coloured heatshrink over the terminals just to remind me which was which then connected the socket.
Next step was to route the cable towards the fuse box. I had removed the tool tray earlier so it was just a matter of running the cable along the subframe.
I fitted an inline fuse to the live wire and then tapped into No 5 fuse (horn) so that there is power to the socket only while the ignition is on. Next step was to test that the socket worked. I have a little compressor which I plugged in. It worked fine.
Finally I re-fitted the tool tray and the seats. This location for the power socket should be much easier for Mandy to use and took less than an hour to do.
It would be pretty awkward for Mandy to use the standard socket on the 1150 so I had a wee look around today to see where would be a handy spot to add an additional socket.
A quick look confirmed that there was enough space for the body of the socket so I decided to put it here;
An 18mm hole was drilled out to take the unit then the cable was fed through the hole. I put some coloured heatshrink over the terminals just to remind me which was which then connected the socket.
Next step was to route the cable towards the fuse box. I had removed the tool tray earlier so it was just a matter of running the cable along the subframe.
I fitted an inline fuse to the live wire and then tapped into No 5 fuse (horn) so that there is power to the socket only while the ignition is on. Next step was to test that the socket worked. I have a little compressor which I plugged in. It worked fine.
Finally I re-fitted the tool tray and the seats. This location for the power socket should be much easier for Mandy to use and took less than an hour to do.

Any good motor factors should have them in stock or anywhere that stocks stuff for trucks.