HexEZCan Gen II Swap the left and right lights over ?

[zerax9]

To save me taking all the plastic trim off (again !) to re-route the cables... does anyone know how you can swap the left and right lights over ? I did hear that the software allowed you to do it... but I've been through every option/drop down/tick box etc. and I can't find the bloody option... and the manual doesn't mention it either... TIA

 

[EPG_19]

To save me taking all the plastic trim off (again !) to re-route the cables... does anyone know how you can swap the left and right lights over ? I did hear that the software allowed you to do it... but I've been through every option/drop down/tick box etc. and I can't find the bloody option... and the manual doesn't mention it either... TIA

If each light is on a channel just change the channels

 

[zerax9]

If each light is on a channel just change the channels

Yeah... that would be way too easy... but I'm using the white channel, which is the clever Bus Channel... 3 cables out, control both lights (plus lots of other things potentially).

 

[Santa-2512]

Read the mandbook, its all explained in there, but in all fairness, i thought it wasn't very clear , and it took me a couple of attempts

 

[XRR]

Yeah... that would be way too easy... but I'm using the white channel, which is the clever Bus Channel... 3 cables out, control both lights (plus lots of other things potentially).

when looking at the outputs panel (i.e. red, blue, yellow, white outputs), there's an arrow to the right of the white output (which should be on ezBUS). Click the arrow, you'll see your left and right light, change the first one to the side it isn't (i.e. if it's currently left, change to right) and vice versa. Bob's your uncle!

 

[zerax9]

when looking at the outputs panel (i.e. red, blue, yellow, white outputs), there's an arrow to the right of the white output (which should be on ezBUS). Click the arrow, you'll see your left and right light, change the first one to the side it isn't (i.e. if it's currently left, change to right) and vice versa. Bob's your uncle!

Thanks for that XRR... I found it in the end. Defo not in the manual though... super easy to do, once you found that bloody arrow !