LITELOK x3

[Pauldevo]

The X1 fits a R1300 GSA with spoked (shown), and my GS with cast.

View attachment 442036View attachment 442037

The X3 fits in exactly the same position on my 1300gsa

 

[Jondd21]

I have one, used many times and never an issue fitting it.

I collected mine personally from the Swansea base. Wonderful staff, quality product and never had an issue with the lock either.

I hope you get your issue resolved .

 

[karlakGS]

Has anyone got for the Hiplok DX1000 on their R1300GS ? Just wondering if it fits the same as the Litelok.

 

[Fiddlesticks]

Has anyone got for the Hiplok DX1000 on their R1300GS ? Just wondering if it fits the same as the Litelok.

It goes around the front tyre and rim. Not the back. Haven't had much luck getting it through the spokes (cast wheels)/forks/bodywork/swingawrm.

 

[karlakGS]

It goes around the front tyre and rim. Not the back. Haven't had much luck getting it through the spokes (cast wheels)/forks/bodywork/swingawrm.

Ah OK. may swerve it for the Litelok X3 then. cheers.

 

[Spook1969]

Litelock x3 fitted my 1250 GSA and my 1200 GS

 

[Gorilla GS]

I’ve just ordered an x3- they have £15 off for the next few days. Use code SEPTEMBER15

 

[Surfboxer]

Fits a treat through the back on my 1300 along with the litelok belt clamped to a fixed object.

 

[karlakGS]

It goes around the front tyre and rim. Not the back. Haven't had much luck getting it through the spokes (cast wheels)/forks/bodywork/swingawrm.

Managed to get the Hiplok DX1000 through the spokes and wheel hub, (spoked wheels_.

Just after an idea of what is considered the more secure method. Round the wheel/tyre or the centre hub. I know a chain etc would be better, but if just using the D-lock, what would be considered the best, or pretty much both similiar. I know the scrotes could lift the bike, use skate board or remove the wheel if they were that determined.

 

[Bubb]

The X3 fits in exactly the same position on my 1300gsa

I couldn’t get the x3 to fit like that on my spoked wheels…

Might get an x1…

 

[twg1]

I am using x1 and x3 on my 1300 gsa . Discovered x1 fits through the two slots of the rear disc and around the spokes of the cast wheel .

 

[GordonR]

Hi All
I've just got a new GS 1300 and am new to BMW and the forum

I am using x1 and x3 on my 1300 gsa . Discovered x1 fits through the two slots of the rear disc and around the spokes of the cast wheel .

I have the X1 and front is easy but any pics of getting it through two slots of the rear disc. I have managed the swing arm and spokes easily enough but couldn't find a way to include the disc

 

[twg1]

Will take a picture later