I have just put D09 Pro's on mine with an Ezcan gen2 and with a bit of basic soldering to put Ezcan pigtails on the harness that cme with the Colights . Total cost was less than £250. They have pretty much the same functionality. Outer DRL in amber which doubles as indicators . Then both sides have high and low beams . It takes 4 channels on the ezcan and I have 2 units to manage all my outputs.
I've got a set for my Stelvio, but there's no EZ-CAN solution for those, so I may use a Dialdim if I can find a used one as I'm not paying £360 quid for a "switch"
I was toying with the idea of just using the wiring / switch / module that comes with the lights but the ability to use as Indicators and dim down some of the lights makes the ezcan a better solution but if you don't have that then they would be fine with wiring that comes with them.I was going to mention just that before the site went down for maintenance
do you have any pictures, and are the lights with or without the ezcan ?
I'd be interested in those if they are already setup for an ezcan (sorry to hijack dj)
Sorry no ezCAN lights only.
Now Sold
No worries. I emailed Colight and they woudn't recommend the CAN option
Interesting. I think they meant more wired into the CAN but with an ezCAN, it's no difference to having Denali's plugged in?
I believe the worst that will happen is the ezcan will shut down the circuit if its overloaded?
Ah of course cause they data lights. Just need a splitter..
I think they do use the same Bus but each device has its own address. I'm off on my hols next week but when I get back I'll get another set of lights and some Y splitters and give it a try. If it doesn't work I'll just get another EzCan. Their smaller lights are ages away yet
