MRA Vario Screen Fitting

[clivewhilde]

Decided to replace my Adventure screen on normal R1150GS with an MRA Vario. The current set up also has Tobinators and I have a bag of bits that I took off a couple of years ago. I want to keep the Tobinators with the Vario, does anyone have a picture of that set up that they could post or send me as I can't see how to fit it? Do I need different Tobinator bits for a standard screen?
Cheers
Clive

 

[Sunny Jim]

Can do better than that Clive - I'm over in Oxenhope so you can either come and have a look or I'll call over to you. (Pse go to PM if you're calling etc).

Binned my Adv screen as soon as I bought the 'bike and put the MRA on, with Tobinators, and the bits you need for the 1150 from Jefferies. (Don't think Tobers ever did the fix for the GSA and MRA screen but will stand corrected).

 

[clivewhilde]

Jim, Thats brilliant! I'm off to Jeffries tomorrow to have some new bearings pressed in to the final drive. Do you know what bits I would need as I don't think I'd get to see you before?

What time do you leave for work?

 

[Sunny Jim]

Sent you a reply to your pm Clive - I'm out the door at 6.45am so a tad too soon even for the staff at Jefferies I'm afraid

Just had a look at the set-up and I think you're going to need the 1150 spacer bit from the cockpit to the screen - will probably have to be ordered in as these relics don't seem to need the same shelf space as the 12's