Navigator 11+ and Mapsource problems-3 questions

[ALEXG]

My Nav 11+ started bleeping at me over bumps and powering down . My dealer exchanged the unit under warranty but its still bleeping at me and they're going to change the cradle too . Anyone had a similar experience ? Bike is a GS1200.

Upon warranty exchange I also got a new set of Mapsource discs and codes . Does anyone know if I have to uninstall the 'old' software and re-install the new - is there a shortcut ?

Anyone found a way of making Speed camera locations audible ?

 

[BurnieM]

You do not have to reload the GPS

On the PC just add in the new unlock codes (assuming you have previously installed the maps from the first unit)

 

[GS Adventurer]

My Nav II+ has been doing the same during a recent 1 week trip through France/Monaco/Italy/Switzerland/Luxembouge/Belgium but not just over bumps - it gives 3 bleeps (sometimes a series of 3 bleeps) and then followed by single bleep and the cursor identifies a location on the screen. Press ESC and it returns to navigation. Thought at first it was heat related as temp was 30+. But continued to do it in cooler temps. Am going to try disenabling touchscreen to see if this cures it. Anyones else had this?

 

[Deleted account W]

Your answer may be here

Or even the link in the last post of that thread

 

[GS Adventurer]

Thanks 'Spaceman Whatton' - will try the insulation tape over IR window trick.

Mike

 

[GS Adventurer]

BTW - it worked!!