Need help please :-) fitting bars raisers

[ide508]

Hello everybody

I've purchased 2 bars raisers from Wunderlich recently but I'm completely unable to place them.
I've took everything apart as recommended but cannot take the damn original bolt out of the "lower" part of the handle raiser to replace it by the new one furnished...

12 diameter will never go into 10 (furnished)... Am I missing something ?

Thanks for you're help

 

[ide508]

To be clear, I just can't figure how to take this bolt out

 

[Rob J]

To be clear, I just can't figure how to take this bolt out

.

Simples,

Simply persuade the top of the inverted bolt (as pictured) with a small hammer. Fitted mine in about 15 mins

 

[outrunner]

They look almost the same as the Touratech ones I fitted to my bike. The bolts came out easily but perhaps there is a bit of corrosion in there so give the bolt a tap and it should fall out.


Andy.

 

[ide508]

Thank you guys

I've tried to place them yesterday eve and didn't want to force it out too much, no luck so I've put everything back in place... will try again this afternoon and apply a little more force

Have a nice weekend

.
Simples,
Simply persuade the top of the inverted bolt (as pictured) with a small hammer. Fitted mine in about 15 mins

Will try that

They look almost the same as the Touratech ones I fitted to my bike. The bolts came out easily but perhaps there is a bit of corrosion in there so give the bolt a tap and it should fall out.
Andy.

Nope, no corrosion

 

[ILMV]

Were a bit tight with mine too... slapped it about with a hammer and hey presto.

Had to persuade the new longer bolt in with a hammer too, it soon knew who was boss.

 

[v8legend]

it soon knew who was boss.

You got the wife to do it then.

 

[ide508]

Were a bit tight with mine too... slapped it about with a hammer and hey presto.

Had to persuade the new longer bolt in with a hammer too, it soon knew who was boss.

Haven't had the time yet but will soon do.
Thanks fellows