New swingarm bearings. Do they look a bit loose?

[Padowan]

Received new swingarm bearings and bushes today. Was just trying them out on the desk and the feel a bit floppy, does this seem correct? Will they tighten up when packed with grease? Or is this meerly the cages moving slightly?

Clip of the movement here:
http://youtu.be/w1KFkJAa0sg

 

[Timolgra]

Put a bearing at each end of the pin then try it but you won't replicate the outer TWO bearings being help in line!
They'll be fine

 

[Padowan]

Ok cool. Do the bearings have a correct orientation as one side looks flatter (the side with the writing on) than the other?

 

[Timolgra]

No they be the same either way around although if one end is flatter I'd be inclined to fit the other end first if there's more of a 'lead' on the corner, be careful to fit them square and without the needles dropping out .........like what happened to me earlier this week on a KTM swing arm!

I use Red and Tacky Grease but any that's sticky and water proof will be ok and it'll also help hold the needles in place when fitting