R1150 GS bits.
These were all removed from a project bike I had a while ago. Yours for the cost of postage.
Front Brake master cylinder cover, scraped but serviceable,
Plastic bit that goes on the screen,
Fuel filter 'O' ring, - replaced when bike was serviced, not leaking at the time, Ok to carry as a spare??
Quick release fuel couplings- one set of 8mm, one set of 6mm, one female half 8mm. I had issues getting these to seal properly, possibly due to the position they were in and getting slight sidewards pressure?.. anyway there are NO 'O' rings in them- the O rings were knackered by the time I had finished messing. They still click together convincingly but will need new o rings.
Hard part for front steering lock. This is new unused- I never could figure out where this was supposed to go... so it went in a bag until now.
Jubilee clip- to go round the TB air intake stub 1150GS
Indicator reflectors, 2 of, 1150 GS. scruffy but servicable, terminals in good nick. Might allow somebody to make up a complete unit
