Non-bike related Free Stuff ........
- Thread starter oblertone
- Start date
ian6760
Registered user
I'll have it if that's ok.
PM on its way.
In the post tommorrow morning to this fine person,
Thank's Camel landy,yes it was.
Mike.
Last edited:
rodsharp
Registered user
No photos but I have leather jacket and trousers suitable for a youngster or small (size 8 approx ) lady. Still in good condition very usable but no longer needed.
dubster
Registered user
Pm sent
Couple of 1150GSA Bits
Nothing too exiting, just a couple of small bits that didn't go with my bike when I sold it last year and having begun a garage Spring Clean found in my odds and sods drawer.
I can't be arsed to post separately so if you want one item you get both.
Original and unused Oil Filler cap (well travelled though as I used to keep it in my tool roll in case the Gucci one fitted broke or fell out).
Coil stick removal tool thing.
First to shout-up gets them.
All I ask is that once they arrive at your chosen destination you have the courtesy to send a one liner either publicly or via PM that they've arrived. No grovelling thank you or protestations of undying friendship are required (it's just that the last thing I sent off for free didn't even elicit a "ta" but then perhaps it's difficult for a Scot to say thanks to a FEB?
). 
Nothing too exiting, just a couple of small bits that didn't go with my bike when I sold it last year and having begun a garage Spring Clean found in my odds and sods drawer.
I can't be arsed to post separately so if you want one item you get both.
Original and unused Oil Filler cap (well travelled though as I used to keep it in my tool roll in case the Gucci one fitted broke or fell out).
Coil stick removal tool thing.
First to shout-up gets them.
All I ask is that once they arrive at your chosen destination you have the courtesy to send a one liner either publicly or via PM that they've arrived. No grovelling thank you or protestations of undying friendship are required (it's just that the last thing I sent off for free didn't even elicit a "ta" but then perhaps it's difficult for a Scot to say thanks to a FEB?
). 
repomanbe
Registered user
Yes please... I'll even collect
No problem Brian
drop me a PM with the address .... i can visualise the place on a corner ! but not 100% which one
Honda XR250 - 1996 - 2004 Workshop Manual CD
Free to good home
Workshop manual on CD for Honda XR250 1996 - 2004.
Sold the bike and forgot to give this to the new owner (not a Tosser!)
First come first served.
Richard
Free to good home
Workshop manual on CD for Honda XR250 1996 - 2004.
Sold the bike and forgot to give this to the new owner (not a Tosser!)
First come first served.
Richard
52blackshadow
Registered user
XR manual - yes please
Yes please, if still available?
Just sending a PM.
Keith.
Yes please, if still available?
Just sending a PM.
Keith.
All yours Keith - I'll post out tomorrow.
Cheers
Rich
Cheers
Rich
Me please if it's free, I've been looking at them over the last few weeks
Toddy
Registered user
Free to anyone that can use it.
About half worn.
Changed to a new set last year before a Germany trip with the intention of refitting this one but changed to a GS.
Collection only please, I'm in Bishopton Refrewshire.
Dave
Give us a clue on brand, model & size
Phil
Give us a clue on brand, model & size
Phil
Phil, looking at the header of his post* (which you might not see if using a phone to view etc), it's a Bridgestone:
* ''BT023GT 180/55ZR17 Fit K1300GT''
Ahh, thanks for that, it doesn't show on the phone!.
No use to me nut thanks anyway.
Phil
2008 R1200GSA Alternator
I have just replaced my alternator as a cautionary change. Nothing wrong with the old one, but at 100K miles the brushes are probably well worn. I was going to replace them, and any bearings if necessary, but I picked uo a cheap 8k mile one on EBay...
Before it disappears into the shed/skip does anyone want it for rebuilding?
I have just replaced my alternator as a cautionary change. Nothing wrong with the old one, but at 100K miles the brushes are probably well worn. I was going to replace them, and any bearings if necessary, but I picked uo a cheap 8k mile one on EBay...
Before it disappears into the shed/skip does anyone want it for rebuilding?
Similar threads
