P clip required for centre stand guard - BUT.....what make is this Guard?????

[tully]

looking for a replacement P clip for this centre stand, sump guard but i don't know which company it is made by....???

it was on the bike when i got it - it has 1150GS cut out of the metal plate, great bit of kit

anyone know who makes/d them please?

before anyone asks, i know its easy to buy P clips.....or is it..... all the ones ive tried to buy online have turned up and don't fit, and it gets quite expensive ordering lots of the wrong ones with postage etc......and ive been to 10+ plumbers merchants etc and so far no luck

any sensible, helpful replies would be greatly appreciated - thanks in advance

smart arses don't bother

cheers, Tully

 

[Stujw70]

Have the other P-clips got any info stamped into the stainless inner if you peel the rubber away?

If not I assume you can measure the diameter of the stand itself and that should give you something to aim for?

Ps apart from the 1150 bit, it looks like a Rugged Roads guard so perhaps a phone call. They are pretty helpful.
http://ruggedroads.co.uk/epages/00c...604-5d1c-407e-8207-580e14387ec5/Products/2018

 

[tully]

p clips

p clips

thanks Stu

worth a try,

sadly the other p clips have rusted too much to read any info

cheers

 

[Tone 1]

measure the stand and order here
http://www.ebay.co.uk/itm/EPDM-Rubb...ikalor-/271200589061?var=&hash=item3f24d09505

 

[Annette]

It's not a Rugged Roads centre stand guard, but the "p" clips will be the same size. Drop me a PM with your address if you still need them and I will put some in the post to you.

 

[Big Al Litch]

The guard looks like a Touratech item but unless anyone knows better, I would say the 1150GS was added afterwards.