Wanted Parts cleaner

[Teamin]

Any recommendations for an ultrasonic parts cleaner?

 

[Santa-2512]

I bought thi a few months a go

https://www.amazon.co.uk/dp/B097ZNFHVM?ref=nb_sb_ss_w_as-reorder_k1_1_4&amp=&crid=2US1D5CRURJNU&sprefix=ultr&th=1

 

[Teamin]

I bought thi a few months a go

https://www.amazon.co.uk/dp/B097ZNFHVM?ref=nb_sb_ss_w_as-reorder_k1_1_4&amp=&crid=2US1D5CRURJNU&sprefix=ultr&th=1

Thanks, and just ordered one

 

[Santa-2512]

You'll also need some cleaner, i used

Carbsonic ultrasonic cleaner for carburettors ( the red stuff) , not cheap, but you dilute it and it goes a long way

Also the instructions ar'nt to clear, if you want a hot clean, you have to heat the tank first and then set the fizz time

otherwise its fizzing and heating at the same time, and the tank may not get to the temp you want

I got my zorst flap in my unit with no problems

 

[SBD]

I use Flash in mine. Not much, just a couple of drops.

Then run it for ten minutes or so to degas the water, that seems to help. I guess you could just run it for longer the first time with new water in.

 

[Santa-2512]

I use Flash in mine. Not much, just a couple of drops.

Then run it for ten minutes or so to degas the water, that seems to help. I guess you could just run it for longer the first time with new water in.

If the op has bought the same as i did, it has a degass setting i did the degass then ran it for 30 mins cold 60 hot 30 cold for a few days