Raising Rear of 1250 GSA Tank

[KevinW]

This is a bit of a forlorn hope but is there any way to raise the rear of the GSA tank without taking off both bodywork and tank?

I want to run three cables under it and out through the middle of the rear of the tank where the wiring harness is running and taking it all off seems overkill although I have a horrible suspicion that's what's required.

Thanks.

Kevin

 

[autogs]

Just take side panels and top tank panels off and cables that way, recently put innov cameras on a gsa and didn't touch the tank

Sent from my SM-A202F using Tapatalk

 

[KevinW]

That's what I did to get the cabling for my aux lights to the battery but now I'm trying to get from the battery to the tail piece. There is space in the channel the wiring harness is running through under the tank to the rear of the bike but I'm struggling to get to it.

The alternative is running it where I've shown in the photo but it just doesn't seem right to run cabling 'outside' if I can keep it inside. I'm not sure I could explain why it's 'wrong' if asked and I'll probably do that if the only alternative is removing the tank.

Kevin