Rear hugger

[donny1972]

Can any tossers recommend a rear hugger for an 04 bike. Seen a few online but not sure what one is best or best value.

 

[bisbee]

http://www.powerbronze.co.uk/

If you are going to the NEC they may do you a deal

 

[trainman]

Can any tossers recommend a rear hugger for an 04 bike. Seen a few online but not sure what one is best or best value.

http://www.nippynormans.com/product...ling-r1200gsadventure-all-years-mam-m-sling09

mudsling very good, this very forum got a job lot some years ago, fits to bike with a couple of small self tappers into plastic and 4 tywraps, no drilling hassle or nuts and bolts reqd, keeps back of engine dry and my gearbox switch hasn't played up since either

 

[Bendy toy]

Mudsling and no wheel shovel keeps mine a lot cleaner than the hugger ever did.

 

[Yonkyo]

http://www.nippynormans.com/product...ling-r1200gsadventure-all-years-mam-m-sling09

mudsling very good, this very forum got a job lot some years ago, fits to bike with a couple of small self tappers into plastic and 4 tywraps, no drilling hassle or nuts and bolts reqd, keeps back of engine dry and my gearbox switch hasn't played up since either

+1
And in my experience, Huggers can rattle quite annoyingly, and are no good if you ever venture off-road :

 

[Wilsdorf]

Mudsling covers the back of the bike/legs more than a hugger - the best option is to use both.

 

[(RIP) Miff]

Don't know what make mine is. I'll try to post up later. It doesn't rattle but then I don't venture off tarmac (apart from my private road)...

It's Tapatalk. Get over it.

 

[Mark Hooton]

bit radical

Bit radical this one............ (I was bored..............)

[/url] photo 4 by cymarceng, on Flickr[/IMG]

[/url] photo 3 by cymarceng, on Flickr[/IMG]

Hope you get sorted at the NEC if you are going pal

 

[Yonkyo]

Bloody hell Mark

Is that a Stainless steel hugger

If it is, that extra unsprung weight will effect your shocks performance and road holding...

Thats why i will only fit a Carbon fiber hugger (which then rattles like a bitch ).

 

[Mark Hooton]

Bloody hell Mark

Is that a Stainless steel hugger

If it is, that extra unsprung weight will effect your shocks performance and road holding...

Thats why i will only fit a Carbon fiber hugger (which then rattles like a bitch ).

pal - good to hear from you again, I hope you are well - no mate, you are right, far too much unsprung weight - I`ve gone off piste and done it in ali and its not unreasonable on weight. I`ve put a full post on a new thread in this section if you care to offer any valued opinions.

Nice though init...........

 

[Yonkyo]

pal - good to hear from you again, I hope you are well - no mate, you are right, far too much unsprung weight - I`ve gone off piste and done it in ali and its not unreasonable on weight. I`ve put a full post on a new thread in this section if you care to offer any valued opinions.

Nice though init...........

It does look quite neat....in an Armadillo kind of way..

Ah, ok Mark, i'll check out that thread then...

 

[Mark Hooton]

It does look quite neat....in an Armadillo kind of way..

Ah, ok Mark, i'll check out that thread then...

ha - armadillo! That's what I was calling it! Crossed with `predator`............