Rear light 06 Hexhead
- Thread starter Santa-2512
- Start date
Should be grand, just give it all a good clean and a blast of one of the moisture repellent/anti corrosion sprays (GT85 etc etc)
Sent from a OnePlusX.
Sent from a OnePlusX.
Just hooked up the 911,
It's the cheap resistor park bulb...
Time to order another ffs
or do i just pull it and go back to filaments .... or faf around resoldering resistors
It's the cheap resistor park bulb...
Time to order another ffs
or do i just pull it and go back to filaments .... or faf around resoldering resistors
Its done. I imported the unit from Germany and got great service. I think the unit is great quality for the money, and it includes everything you need for plug and play. The instructions are great, and installation was a breeze - couple of hours and I took the time to heatshrink the connections.
Attachments
Bendy toy
Registered user
Did you check for corrosion on the brackets behind the plastic bodywork?
I didn't make a point of it to be honest. I use my bike daily and don't want to start getting into it in a big way, and the luggage racks add to the work. What I could see wasn't too bad, a bit of surface rust. Perhaps I'll get the racks off with a view to having a better look, and spray liberal quantities of anti rust stuff in there...
Bendy toy
Registered user
Mine at 50K were a horrible mess. Just checking mine the other day, the coating has lasted so far. But the little alloy spacers to the stainless carrier are looking badly furred up. I'll be talking to MistaCat to get some made in stainless.
Delboy777
Registered user
Premium quality ehh ?
Bendy toy
Registered user
Premium quality ehh ?
Just like my fekked up rear brake caused by the almost never used master cylinder wearing out. Probably. Not yet changed it out so can't be sure.
Right , back to square one. Got another 07 GSA and need to do the same again.
€139 for OEM (with possible recoding)
or
€69 for the Hornig
Decisions. decisions!!
€139 for OEM (with possible recoding)
or
€69 for the Hornig
Decisions. decisions!!
Bendy toy
Registered user
Premium quality ehh ?
TBH going orange does have it's attractions but costs to change are well behind me for now.
Are you happy with the light output of the unit.And the final result - very pleased with it. And NO Lampr error!!!
The OEM unit is "night and day" compared to the standard filiment unit.
Do you think this is a major improvement in performance (if obviously is in the looks department)
Sent from a OnePlusX.
Got this email back regarding the retrofit OEM BMW unit.
Sent from a OnePlusX.
Sent from a OnePlusX.
Bendy toy
Registered user
I think we already said the ECU has to be reset on GS-911 to go from filament bulb to LED.
I was only in the market because the OEM unit was faulty and I wanted a good replacement that was value for money. The OEM has the ridiculous design of the terminals hanging out the back in the elements, so the LED I bought was a major improvement. The LED works great, performance is in my opinion much better than OEM. It appears to be one the cheapest on the market and is plug and play - no resetting needed on mine. Personally, I would highly recommend it as a replacement unit.
Thanks, that's my mind made up. I might go for the frosted option on the Horning site.
Cheers for the heads up.
Sent from a OnePlusX.
Similar threads
