Rear Shock lengths.

[Vern]

Does anyone know where I can fine the rear shock lengths for the 1150 range,like the GS,ADV,R abd RT.

I can find plenty of different stuff on them,but not the lengths.

 

[Tsiklonaut]

Whaddya need for?

1150 supposed to be the same as 1100 (minus different bottom mount design) but 1150 ADV is deffo longer.

I don't think the manufactures specify the shock lenghts, only wheel travels.

Also I know there's some play room between different 3rd party shock manufactures in lenght - ie. lowered shocks or ie. Hyperpro makes couple of millimeters longer than stock and also longer travel.

So I guess the best is to take 'em off and measure them on the spot.

 

[Timolgra]

I have a new standard adv shock which I can measure between centres if that helps.

 

[Vern]

It would be a start.

Ta muchly

 

[nud1e]

This any use

 

[Vern]

Useful if they are the same as the stock stuff

 

[Timolgra]

It would be a start.

Ta muchly

I forgot

Tomorrow

 

[nick.ct]

http://www.yss.co.th/result_moto.php

 

[Tsiklonaut]

Hyperpro for R850/1100/1150GS

Measured the Hyperpro for R1100GS from mounting points center of the bolt hole to another (the moving points where subframe attaches to swingarm) in the extended position.

Más o menos: 363mm (+/-2 mm)

In the max collapsed position it's hard to measure since there's this bumper-rubber that takes the "bottom-out" shock and I don't have long enough pressure tools to properly compress it with force.

Also I didn't have the spring attached on the shock thus with the spring it the above lenght spec can be a little longer since in the inside of the shock there's similar small spring for the "rebound landing" that's not fully used w/o the shock's main spring.

http://www.yss.co.th/result_moto.php

Pretty sure this 380mm looks to be the overall lenght over the both ends, not from the mounting points(?)