Just a quick question.
I've just replaced the RHS shaft seal on the final drive.
Prior to replacement there had been abouth a centimetre of dampness on the casing around the seal, no drips or puddles.
As there was so little 'apparent' fluid loss, would you drain and replace the fluid?
(As there's no way to determine the level within, due to bad design and no fill-to-level hole).
I've just replaced the RHS shaft seal on the final drive.
Prior to replacement there had been abouth a centimetre of dampness on the casing around the seal, no drips or puddles.
As there was so little 'apparent' fluid loss, would you drain and replace the fluid?
(As there's no way to determine the level within, due to bad design and no fill-to-level hole).
