Screens.....

[RROB]

Who uses what ??

Ok I'm sure its been asked a zillion times.... if so I apologise for not searching

Cant decide on Givi airflow or MRA Vario ? or is their another popular choice

Any advice would be appreciated

 

[Bounce]

I simply have an OEM dark tint screen.....works perfectly

 

[Greenman14]

I simply have an OEM dark tint screen.....works perfectly

+1, though mine's about 20mm taller than a standard screen. You'll find me and Bounce are on our own on this one.

 

[Bumhead]

+1, though mine's about 20mm taller than a standard screen. You'll find me and Bounce are on our own on this one.

No, I am the same as you.

 

[BigDan]

I bought the MRA X-creen spoiler to put on my GSA, works a treat because you can angle it however you want.

 

[streaky]

Standard tint for me , Works fine


Sent from my iPhone using Tapatalk

 

[RROB]

+1, though mine's about 20mm taller than a standard screen. You'll find me and Bounce are on our own on this one.

So yours isn't quiet standard ??

 

[RROB]

Maybe I'm not giving the standard enough of a chance...... just found quiet a bit of helmet turbulence when I brought her home a couple of weeks ago ??

 

[Bounce]

Maybe I'm not giving the standard enough of a chance...... just found quiet a bit of helmet turbulence when I brought her home a couple of weeks ago ??

I had the OEM standard clear screen & switched for the OEM standard dark tint screen.....never had an issue with helmet turbulence before; does your helmet have a peak, and if so....is it loose?

 

[Mr Derek]

MRA Vario for me. Cuts out turbulence for me and pillion. Brilliant!

 

[RROB]

I had the OEM standard clear screen & switched for the OEM standard dark tint screen.....never had an issue with helmet turbulence before; does your helmet have a peak, and if so....is it loose?

No peak..... Nothing loose either....

 

[T-mac]

I had the standard but I dropped the bike and cracked the screen. It was perfectly fine but I found a taller wider screen on eBay (cheap because I'm a tight arse). It was utter shite, I couldn't put up with the turbulence.
I've since replaced that one with an Mra vario screen and it's much better, although I can't really say I would replace a standard screen given the option again.

 

[Rocketman]

At number 3 in my best mods so far list ..
1. Wilbers
2. Sergeant seat
3. Givi screen

 

[lawvar]

MRA Vario for me. Cuts out turbulence for me and pillion. Brilliant!

Not for me im sad to say although to be fair got to try a few more positions with the spoiler but I gat a lot of turbulence
Not much difference to the standard GS sreen.
I had the Givi airflow on my Suzuki V strom and it worked a treat but not sure it looks right on the GS ?

 

[adventuredon]

had original for 18k. Had MRA Vario for 500 miles..Givi airflow barn door works the best for me, now on 51k. Cannot fault it. Vario hit me with too much rain, normal was fine and looked better but just too short. Love the GIVI -

 

[danjacks]

Another standard in the dark tint. I'm 5'10 so perfectly high enough for me.

 

[bigmadstu]

OEM std on the GSA with one of them touratech clamp on extenders as I was getting loads of buffeting on the helmet. I have the screen in the low position now with no buffeting.

 

[Vmax666]

Givi for me
Standard way to much wind noise with a shark helmet
But givi causes more engine noise but works best with visor open

 

[Beemerman59]

I'm 6'3" and had a lot of sideways buffeting with the standard GSA screen. Replaced it with a Ztechnik touring screen which is supurb - no buffeting, nice and quiet and I can still see well over the top. I rate it one of my top three mods along with Wilburs WESA and a Hilltop remap.

 

[TLSgazza]

I kept the standard gsa screen, had a lot if buffetting until I fitted a small adjustable puig screen extender, instantly went away, cheaper than a different screen.