suspension lowering kit

[RSiconic]

I bought the Touratech -20mm springs and had them installed in my full height GSA. This with a std seat means I can have one foot flat or two on balls of feet. Ideally it could do with being another 20mm lower but I will just soldier on until I replace the bike.

 

[JonB]

I bought the Touratech -20mm springs and had them installed in my full height GSA. This with a std seat means I can have one foot flat or two on balls of feet. Ideally it could do with being another 20mm lower but I will just soldier on until I replace the bike.

I have a standard height bike with touratech extra low seat and lowering cams on the seat adjusters. Its not too bad but the seat is quite hard and gets quite painful in the lower back.

 

[Santa-2512]

I have a standard height bike with touratech extra low seat and lowering cams on the seat adjusters. Its not too bad but the seat is quite hard and gets quite painful in the lower back.

I have the TT extra low as well, they get softer with time ( just trying some padded underwear next)

 

[TomP]

Mine’s a factory lowered 2015 GSA. Was mentioned almost as an afterthought by the dealer I bought from - maybe it puts some people off - but it suits me (31 inch inside leg) just fine. Only time it has been an issue To bear in mind was when I fitted aN aftermarket side-stand “footprint enlarger”, and found that the one for factory lowered bikes is different to the one for other 1200 GSAs.

Tom