SW Motech crash bars help

[Sweetpea]

Hi all

I've obtained a 2nd hand set of engine crash bars for my 2004 GS.

I am missing the longer 75mm hex head bolts and frame spacers for the rear lower bars.

Does anybody know where I can get some? I've emailed Sw motech but not had a reply as yet.

Do you think this will be the only source for these?

Thanks

SP

 

[Bendy toy]

How would we know? Pictures at least needed.

The OEM bars bolt to the front bolt hole but the back just sits into the rear frame lug. It's only bolted once at the bottom end. .

 

[ibgarrow]

I've got them on my 2017 LC - supplied with some spacers which the '17 doesn't need. What size are you missing? I'll fish mine out and have a measure up tomorrow.

 

[Sweetpea]

How would we know? Pictures at least needed.

The OEM bars bolt to the front bolt hole but the back just sits into the rear frame lug. It's only bolted once at the bottom end. .

Sorry I've tried to attach a picture to show but it's a Pita as photo bucket is down.

Here is the bolt and spacer in question

Hex head bolt is M12 x 80

Spacer is 28 x 25 x 12.5

Hope this helps

SP





Sent from my iPad using Tapatalk

 

[Sweetpea]

I've got them on my 2017 LC - supplied with some spacers which the '17 doesn't need. What size are you missing? I'll fish mine out and have a measure up tomorrow.

That would be very much appreciated. I hope it's a standard kit and also hoping that Motech will confirm soon.

SP


Sent from my iPad using Tapatalk

 

[Bear]

Does this help:- http://www.motohaus.com/acatalog/sbl_07_562_100.pdf and http://www.motohaus.com/acatalog/sbl_07_552_100.pdf

 

[buncobooth]

Does this help:- http://www.motohaus.com/acatalog/sbl_07_562_100.pdf and http://www.motohaus.com/acatalog/sbl_07_552_100.pdf

I was going to say contact Motohaus. I have ordered odd spares and screws for SW Motech racks and Bags Connection tank bags from Motohaus, as long as you know the part number you need I think they should be able to order it.

 

[Sweetpea]

Cheers guys.... i'll check those links out today and give them a ring

Thanks

 

[Sweetpea]

Well after a visit to my local fastener / engineer store I have now managed to fit my engine crash bars.

I simply ordered the bolts which were M12 x 80 and ordered enough stainless washers of the correct size in order to make a spacer inside the frame.

Total cost £2.00 cash in hand!

Well chuffed with the result.

Thanks all for the suggestions and advice

SP


Sent from my iPad using Tapatalk