Swingarm Removal GSA/06 Help needed

[redpadraig]

Manual states a Special Tool is required "A slide hammer" for drawing out the right hand bearing pin. Is there an alternative (home made) way of drawing out the bearing pin?
Any help really appreciated

 

[redpadraig]

Swingarm Removal

Further to my original thread no Special Tool is required. Find a bolt that will fit the right-hand bearing pin centre hole then with a piece of steel or similar hard material that will fit across the opening where the bearing pin is located drill a hole in the centre of the steel a little larger than the bolt. Put the bolt through the steel and then screw into the centre hole and tighten. By doing this it will pull the bearing pin out of its location.

 

[solidstate100]

Good tip. thanks