Throttle body balancing

[ELIMINATOR]

I can borrow a pair of digital manometers, they each apparently have only one take off point..

Question, will this be OK, as my thoughts are that the usual method is to use one manometer, each end connected to the throttles. Will two separate manometers do the same thing? I'm convinced they will, but won't be doing it this week, so I thought I'd as k the wise.

 

[Burfcontrol]

Should be OK, just make sure they both read the same. Best way is to connect each one to the same carb before you start and check they give the same reading. I'm still using the good old dial gauges, do the same thing each time I use them, make sure I zero all the gauges to the same carb before I start. Try them at different rev settings as well to be sure they respond the same way. Once you've done that you'll just need to get the same reading on each one during the balancing process. Piece of

Jim