AxeGrinder
Registered user
Hi...not been on for a while, but my bike is now 95% rebiult, and I have a problem
On the carburtter/throttle body of my twin spark 650 (2003), there is what appears to be a vacuum pipe connector, this is a right angled fitting, about 1" on each part of the elbow. It is located just below the butterfly, on the right side of the carb.
I can't find a hose/pipe to connect to it...does anyone know what should be connected to this fitting? There are a couple of overlow/drain pipes which fit but I don't think this would be conected to an open pipe????
I've checked my manual, and can't find any mention of it...but am concerened that there will be an air leak...
Foolishly, when I stripped the bike, a month or so ago, I didn't note what as conncted here, if anything!
Any info would be great!
On the carburtter/throttle body of my twin spark 650 (2003), there is what appears to be a vacuum pipe connector, this is a right angled fitting, about 1" on each part of the elbow. It is located just below the butterfly, on the right side of the carb.
I can't find a hose/pipe to connect to it...does anyone know what should be connected to this fitting? There are a couple of overlow/drain pipes which fit but I don't think this would be conected to an open pipe????
I've checked my manual, and can't find any mention of it...but am concerened that there will be an air leak...
Foolishly, when I stripped the bike, a month or so ago, I didn't note what as conncted here, if anything!
Any info would be great!
