Wassal HID 50 12v ballast connector problem

[Slowdown]

I've stupidly taken the pins out of the 12v connector that feeds the ballast on Les's 50w ultra thin jobbies. Only I didn't note the polarisation.

Can anyone tell me if I've got it the right way round or not?

 

[Big Lee]

First you need to press the macro button on your camera

 

[Attleborough]

Based on the set I have the pair sockets only fit one way, i.e. you can't get the wrong connector in the wrong plug. Can you check and see if this is the case?

 

[Slowdown]

First you need to press the macro button on your camera

I know I'm not David Bailey. You get the gist though... With the clamp bit facing you, is the blue wire at the bottom or the top???

Based on the set I have the pair sockets only fit one way, i.e. you can't get the wrong connector in the wrong plug. Can you check and see if this is the case?

I've had the pins out - I can't believe I didn't take notice of the wire polarisation



Edit - actually it doesn't matter, 'cos there's no instructions on how to connect the male spade connections at the other end...

Les???

 

[brassmonkey001]

I thought there were four wires from that picture but I realise they're shadows.
Looking at my 35W kit I've got by the side of me waiting to be fitted, You have the wires correct. The blue wire is the positive.
I'd wait for Les to confirm before fitting though, just in case the 50W is different from the 35W.

 

[ELIMINATOR]

First you need to press the macro button on your camera

Thank ferk for that, thought i was more pissed than I am!

 

[Les Wassall]

Mailed you with the answer I hope

 

[Slowdown]

Mailed you with the answer I hope

Yes - thanks! You have another mail!