Wintec A80 & Kenwood 3201 issue

[Baz]

Hi

I have picked up a couple of Wintec A80s which I want to use for B2B Comms along with a Kenwood 3201.

I dont have the Wintec Autocom Interface leads as yet and have been trying to get the different radios talking to each other just using the PTT on the radios.

1. The two wintecs will send & recieve voice .

2. If I key the Kenwood, both Wintec recive voice

3. If I key either Wintec, the Kenwood is recieving as the Rx green LED lights up, however I dont get any voice

Anyone know what I'm doing wrong?

Ta

Baz

 

[Bumpkin]

You don't have the CTCSS set up correctly, these are the tones and QT/DQT Settings for each channel below.

This is assuming that your Kenwood it set to the default factory settings.

 

[Baz]

The Kenwood is the default settings.
I'll see if I can work out how to change the CTCSS

Ta

Baz

 

[roddy]

you may find this easier to interprete >>HERE<<

 

[Baz]

Now I understand. Sorted thanks