x challenge rotor

[crispy duck]

Does anyone make a 320mm rotor to fit the x challenge ? or a 320mm rotor from another bike model that will fit?

 

[dean0n0]

Isn't the Xmoto a 320mm disc? (though I don't know if it'll fit the Xch)

 

[crispy duck]

it is 320mm but the hole centers on the x challenge hub is 120mm and the hole centers on the cast rim are smaller. not sure on the hole centers on the cast wheels i will check tomorrow. unless i had a brain dead moment when i offered it up but i will check it again to make sure.

 

[Losttheplot]

Try Talon engineering.

 

[GFJ]

I've fitted one from a Dakar in the past; no issues.

Someone on eBay is advertising one for the challenge, country and f700gs, which would suggest they may be the same, but maybe confirm with them 1st?

 

[GFJ]

I've fitted one from a Dakar in the past; no issues.

Someone on eBay is advertising one for the challenge, country and f700gs, which would suggest they may be the same, but maybe confirm with them 1st?

 

[mhsnowy]

I spoke to someone in Holland at the weekend and he is going to fit a floating disc from an 800 I believe.

 

[crispy duck]

Did he say it was a straight fit? I haven't found anything as of yet but it's on the list of many things i need to get done. It would be nice if there was a list of all rotors,wheel spacing and offset.