So rocky burns has been making some axle pullers and has made some custom one's based on the sizings I provided for the XC front axle
https://www.ukgser.com/forums/showthread.php/526471-Ktm-Husqvarna-axel-pullers
Axle puller is very well made and was a breeze to fit
Popped the Axle puller in the freezer for a few hours to shrink it
Removed the front axle from the bike as normal
Cleaned out the inside bore with a bit Scotchbrite to remove any corrosion
Heated the end of the axle up to about 100 degrees C
Inserted the axle puller stub unto the bore of the axle and tapped home with a mallet
Let it all cool down and axle puller is a firm fit with no movement at all
Re fitted the axle to bike
So now no more looking for a screwdriver to put in the cross drilled hole to remove the axle ;-)
https://www.ukgser.com/forums/showthread.php/526471-Ktm-Husqvarna-axel-pullers
Axle puller is very well made and was a breeze to fit
Popped the Axle puller in the freezer for a few hours to shrink it
Removed the front axle from the bike as normal
Cleaned out the inside bore with a bit Scotchbrite to remove any corrosion
Heated the end of the axle up to about 100 degrees C
Inserted the axle puller stub unto the bore of the axle and tapped home with a mallet
Let it all cool down and axle puller is a firm fit with no movement at all
Re fitted the axle to bike
So now no more looking for a screwdriver to put in the cross drilled hole to remove the axle ;-)