Cheap 1200 Y-pipes on ebay.

Yeah, I got one from him some months back. They fit very well and the sensor threads are good etc, no probs. Seem well made.
 
I'm thinking of these, but was wondering if they will fit with Hepco and Becker engine bars. Do you have these on your bike millard?
 
Yes I got some and the quality was second rate to be honest. The pipes had indentations and vice/machine grip marks all over, I did manage to polish a lot of them away with a LOT of hours work with my polishing kit.
In defence of the makers I didn't bother to moan to them, I'm too soft for my own good and hate moaning/complaining.
Maybe I was just unlucky and got the late Friday early Monday job, I would say don't expect Remus quality.
I hope this helps.
 
I can kind of live with a rougher finish as they are available for less money than a second hand set of remus headers go for. My main concern is that alignment is a pain to achieve. I've got SW engine bars so whether they fit with those is also a concern I guess, can anyone confirm they follow the same lines as the stock headers/cat and therefore be all ok?
 
I've got these SW Motech's and they don't interfere with the pipes.

http://cgi.ebay.co.uk/SW-MOTECH-Stu...tcZphotoQQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Fit of the Y pipes is very good, I didn't have to piss around at all, they went straight on.
No "vice/machine grip marks" on mine as on ChrisH's although there are indentations on the bends and they have discoloured quite a bit after about three months, but then I don't really go in for cleaning bikes very much.
I'd buy from them again coz they did what I wanted at a reasonable price
which was to get rid of the Cat and give it some more midrange grunt. That was noticeable even before I got a second hand remus can and dumped the original.

Millard

PS

sorry for the late response to ExpatinInstabul's question, missed it until today.
 
Cheers Millard, they're exactly what I've got!

Just need to decide whether I want an exhaust or a PS3 more...:augie
 
No problems in fitting and aligning and I have upper and lower engine bar kit. As I said mine did come with a lot of marks, dints vice grip marks etc although I did manage to polish a lot of them out and make them so only I know they are there if you know what I mean... well me and everyone who reads this thread:blast
 


Back
Top Bottom