a_bakla
Registered user
Here are some modifications of my g/s; oil pan spacer and custom dashboard
...............
I removed oil pan and measured all dimentions and geometry then draw it in autocad 1:1 scale
autocad drawing...suitable for all type247 engines
A friend help me to find a waterjet cutting place.
Waterjet cutting as per the autocad drawing, (20mm thick aluminium)
it is looking nice.
made hole in to new part with oil pan
<?xml:namespace prefix = o /><o
></o>
<o></o>
Gaskets are cut
<o></o>
<o></o>
Without spacer
<o></o>
with spacer
<o></o>
The oil capacity of G/S (2.2lt) increased to 3lt, and clearence reduced 2cm...<o></o>
To extend oil pick up
<o></o>
<o></o>
Then decided to add oil temp sensor
<o></o>
Isolate cables of sensor socket
<o></o>
<o></o>
New clerance. it is ok for me, same hor. line with the center stand
analog temp gauge installation...
<o></o>
<o></o>
<o></o>
After that I want to add some guagues too, voltmeter,oil pressure and fuel level,12v output also dont want to make any permanent changes on the bike,I want to make it all removable easily
I used 5mm plexiglass, I formed it heating by high temp air gun... It was transparent so needed to paint,that is not my choice it was the materail that only can find...Oil pressuure gauge is the electrical ones<o></o>
<o></o>
<o></o>
<o></o>
<o></o>
...............
I removed oil pan and measured all dimentions and geometry then draw it in autocad 1:1 scale
autocad drawing...suitable for all type247 engines
A friend help me to find a waterjet cutting place.
Waterjet cutting as per the autocad drawing, (20mm thick aluminium)
it is looking nice.
made hole in to new part with oil pan
<?xml:namespace prefix = o /><o></o>
<o></o>Gaskets are cut
<o></o><o
></o>Without spacer
<o></o>with spacer
<o></o>
The oil capacity of G/S (2.2lt) increased to 3lt, and clearence reduced 2cm...<o
></o>To extend oil pick up
<o></o>
<o></o>Then decided to add oil temp sensor
<o></o>Isolate cables of sensor socket
<o
></o>
<o></o>New clerance. it is ok for me, same hor. line with the center stand
analog temp gauge installation...
<o></o>
<o></o>
<o></o>
After that I want to add some guagues too, voltmeter,oil pressure and fuel level,12v output also dont want to make any permanent changes on the bike,I want to make it all removable easily
I used 5mm plexiglass, I formed it heating by high temp air gun... It was transparent so needed to paint,that is not my choice it was the materail that only can find...Oil pressuure gauge is the electrical ones<o
></o>
<o></o>
<o></o>
<o></o>
<o></o>