aslan
Registered user
Hi - sorry if this has already been answered previously but I've struck problems attempting to do my own 80k service - replacing fuel filter etc.
On reassembly I had major challenges getting the new rubber o ring that goes between the fuel gauge mounting flange and the tank such that the fuel was pouring out between the flange and the tank.
When simply testing to see whether I had resolved the problem- with the tank partially installed - I was able to get the bike to fire up and run as normal.
However as the leak was still present I simply persisted until I got the o ring seated properly and the leak apparently resolved.
On reassembly the sound emitted by the fuel pump has changed - higher pitched sound and the bike will not fire.
I was careful to make sure fuel hoses went back in the same place as before disassembly and have the fuel filter facing in the correct direction.
Any helpful comments greatly appreciated please - thanks in advance
On reassembly I had major challenges getting the new rubber o ring that goes between the fuel gauge mounting flange and the tank such that the fuel was pouring out between the flange and the tank.
When simply testing to see whether I had resolved the problem- with the tank partially installed - I was able to get the bike to fire up and run as normal.
However as the leak was still present I simply persisted until I got the o ring seated properly and the leak apparently resolved.
On reassembly the sound emitted by the fuel pump has changed - higher pitched sound and the bike will not fire.
I was careful to make sure fuel hoses went back in the same place as before disassembly and have the fuel filter facing in the correct direction.
Any helpful comments greatly appreciated please - thanks in advance