beemer pimp
Registered user
Alrite All , any know is there difference in camshaft Gs vs RT ? Or it's same one ?
Val
Val
1100 camshaft GS vs RT
- Thread starter beemer pimp
- Start date
MAX BMW Fiche gives the answer.
There is some differrence.
These bikes have the same camshaft
Part number 11 31 1 341 560
R1100 RT has part number 11 31 1 340 963
Pekka
beemer pimp
Registered user
Alrite Pekka . Yeah I did had look on real oem , but could GS cam can be used on RT , less power more torque ?
I got Gs head for Rt , should I swap cams ?
I got Gs head for Rt , should I swap cams ?
No idea of that.
Please try to use the GS head cams.
And tell us your feelings afterwards.
Pekka
the cam shaft is different and there are write uos about that and the different characteristics of each. I dont have any of that information book marked.
Also, there are different length inlet ducts. The length of in let duct can also affect the characteristics of an engine as well. From memory, a short inlet for quicker revving, a long inlet for more torque slower reving.
I use the parts fishce on MaxBMW for all my reference
http://www.maxbmwmotorcycles.com/fiche/DiagramsMain.aspx?vid=51668&rnd=07012015
yes, the cams are different, but what they mount to - the next higher assembly or intermediate part - is that different?
You need to do your own research and make your own decision because it is your bike and could potentially cause a catastrophic failure.
Me - I would install them
I would also install some of Lennies Sprokets. These enable better tuning of the engine.
I haven't installed them because I am happy with my 1150gs, but if I was going to the effort of changing cams, I would install them.
http://boxer-performance.com/boxer-performance/
Also, there are different length inlet ducts. The length of in let duct can also affect the characteristics of an engine as well. From memory, a short inlet for quicker revving, a long inlet for more torque slower reving.
I use the parts fishce on MaxBMW for all my reference
http://www.maxbmwmotorcycles.com/fiche/DiagramsMain.aspx?vid=51668&rnd=07012015
yes, the cams are different, but what they mount to - the next higher assembly or intermediate part - is that different?
You need to do your own research and make your own decision because it is your bike and could potentially cause a catastrophic failure.
Me - I would install them
I would also install some of Lennies Sprokets. These enable better tuning of the engine.
I haven't installed them because I am happy with my 1150gs, but if I was going to the effort of changing cams, I would install them.
http://boxer-performance.com/boxer-performance/
beemer pimp
Registered user
Thanks for you answer Hay Ewe . Reason I want change head cause I got them cheep and exhaust stud on my snapped and gasket was leaking so job need to be done , New heads coming from GS with cams, so it be easy just swap them but I won't take chance and swap cams too.
Val
Val
